Product ID:CORDOBOND STRONGBACK HARDENER
MSDS Date:01/01/1985
FSC:8040
NIIN:00N001609
MSDS Number: BCHWT

Emergency Phone: 203-853-2123

Cage: 0LG38

Telephone: 805-968-5000

Cage: 0LG38

TRIETHYLENETETRAMINE

CAS: 112-24-3

RTECS: YE6650000

Effects of Overexposure:SKIN & EYE DAMAGE. INHAL OF VAPS CAUSE
PERMANENT INJURY.EXPOS TO SMALL AMTS CAUSE SKIN SENSITIZATION

First Aid:INHALATION: REMOVE FROM EXPOSURE. SKIN & EYE: FLUSH WITH
WATER FOR 15 MINUTES. CALL PHYSICIAN FOR EYE CONTACT.

Flash Point:275F,135C, TCC
Extinguishing Media:CO*2 OR DRY CHEMICAL
Fire Fighting Procedures:USE SELF-CONT BRTH APPAR
Unusual Fire/Explosion Hazard:IGNITION HAZ IS SLIGHT WHEN EXPOSE TO
HEAT OR FLAMES. CAN REACT WITH OXIDIZING MATERIALS.

Spill Release Procedures:PROTECT EYES & SKIN FROM FUMES. WEAR BUTYL
RUBBER GLOVES. FOR LARGE SPILLS & LEAKS, WEAR COVERALLS. USE FACE
SHIELD & ALL-PURPOSE CANNISTER MASK, UNIVERSAL TYPE N OR SELF-CONT
BRTH APPAR.

Handling and Storage Precautions:DO NOT STORE > 125F; 51C. CONFINE
MIXING,LAY-UP & CURING TO EXHAUST VENTED AREAS OR OUT DOORS.
MAINTAIN CLEAN WORK AREA & EQUIPMENT.
Other Precautions:WHEN ADDING HARDENER TO RESIN,EXOTHERMIC REACTION
OCCURS WITHIN 15-20 MIN, REACHING TEMPS 400F;204C. AVOID INHHAL OF
FUMES & BURNS WITH RESIN OR CONTAINER. WIPE UP SPILLS IMMEDIATELY.

Respiratory Protection:USE NIOSH/MSHA APPRVD ALL-PURPOSE CANNISTER,UNIV
TYPE N,SCBA (MFR)
Ventilation:LOCAL: OUTDOORS. MECH: INDOORS TO KEEP BELOW TLV.
Protective Gloves:BUTYL RUBBER
Eye Protection:FULL FACE SHIELD
Other Protective Equipment:COVERALLS OR OTHER HEAVY WORK CLOTHES TO
PROTECT SKIN
Supplemental Safety and Health
PART B OF TWO PART KIT.

Boiling Pt:B.P. Text:513F,267C
Vapor Pres:<1
Vapor Density:5
Spec Gravity:0.98
Solubility in Water:COMPLETE
Appearance and Odor:FLUID, STRAW COLORED LIQUID, MILD AMMONIA ODOR

Stability Indicator/Materials to Avoid:YES
OXIDIZING MATERIALS
Stability Condition to Avoid:OXIDIZING MATERIALS, HEATING TO
DECOMPOSITION
Hazardous Decomposition Products:CO, CO*2, AMMONIA, NITROGEN OXIDES

Waste Disposal Methods:MANUFACTURER RECOMMENDS COVERING WITH LAYER OF
SODIUM BISULPHATE. SPRAY WITH WATER. WASH INTO DRAIN WITH LARGE
EXCESS OF WATER. DISPOSAL METHODS MUST BE IAW FEDERAL, STATE &
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.